top of page

Genuine Fujitsu Air Conditioner PCBs

Get your system thinking straight again with the exact Fujitsu air conditioner PCB your unit was built with. Add your model number at checkout and we'll check it's the right part before it's sent.

Buy with confidence

Add your model number at checkout, and we'll confirm you've ordered the right part before anything leaves us. If it doesn't match, we'll contact you first. No wrong board arriving, no return to sort out, no second callout.

​

Rather check before you buy? Call 1300 904 554 or email fujitsu@nationalacparts.com.au.

Why a failing PCB matters

A PCB (printed circuit board) is your unit's electronic brain. It reads the sensors and runs the fans and compressor. When a board fails, the unit can show an error code or refuse to start. A genuine Fujitsu air conditioner PCB brings back reliable control.

The right PCB for your unit

Boards are made for particular models, and two that look alike may not swap over. Indoors, you'll find the Fujitsu indoor control PCB, plus power, filter and Fujitsu display PCB types. Outdoors, there's the Fujitsu outdoor main PCB and the Fujitsu inverter PCB, which controls compressor speed. Transistor, capacitor, power, filter and communication boards are here too. That's why the part has to match your model, and why we check it for you.

Everything the repair needs

We also list connector wires, harnesses, a wire cover, a PCB holder and a heat sink. Where a repair needs more than one part, a "Further Part Required" label tells you, so a second order doesn't hold up the job.

Genuine, from an authorised distributor

We're an authorised Fujitsu spare parts distributor, and we order every part from GENERAL Australia. Each one is genuine Fujitsu, carries a 12-month manufacturer warranty and ships express Australia-wide.

​

Technicians: the exact board confirmed, express delivery, one trip to finish the job. ARC licence holders get 10% off spare parts.

​

Homeowners: a genuine board, checked against your model, and a system that responds again. PCBs carry mains power, so a licensed, qualified person must fit them. That's also a condition of your 12-month warranty.

bottom of page